FARGO Electronics C16 Service Manual - page 32
RESTRICTED USE ONLY
Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0)
23
Reviewing the TOP Line LCD Error/Status Messages (continued)
Message Cause
Solution
Mag Verify Error
The mag stripe was not encoded
properly.
See the
Resolving the Mag Verify
Error Message
procedure in
Section 2, page 46.
Mag Verifying
Indicates data on mag stripe is
being verified.
No action required.
Print Cover Open The Top Cover is not properly
shut.
See the
Resolving the Cover
Open Error Message
in Section 2,
page 31.
Printer Ready
Indicates Printer is ready to
print.
No action required.
Printing
Indicates Printer is printing.
No action required.
Rib Calib Failed
The attempt at calibrating the
ribbon Sensor through the
Printer Driver has failed.
Be sure the ribbon is removed and
that the Printer's Top Cover is
closed. Try calibrating again.
Ribbon Error/Out
The print ribbon is either out or a
ribbon error has occurred.
See the
Resolving the Ribbon
Error/Out Error Message
procedure in Section 2, page 40.
Ribbon Jam/Out
The print ribbon has become
jammed in the Printer rollers, is
stuck to the surface of the card
or is out.
See the
Resolving the Ribbon
Breaking issues
procedure in
Section 2, page 40.
Sensor Calibrate
Indicates the Ribbon Sensor is
calibrating.
No action required.
Wrong Ribbon
The wrong print ribbon is
installed.
See the
Resolving the Wrong
Ribbon error (being displayed
incorrectly)
procedure in Section
2, page 38.