Farymann Diesel 15B Series Operator's Manual - page 68
Diesel engine Series 15B / 18B
Maintenance
68
2008-09-08
8.6 Changing engine oil
NOTE!
Only change engine oil when the engine is at a
standstill and at operating temperature. Always
replace engine oil and oil filter together.
8.6.1 Version
with oil drain plug
Fig. 41
1.
Switch off the engine
2.
Slacken oil drain plug (1) (e.g. with a ring spanner SW 13).
3.
Place a suitable container underneath.
4.
Screw out oil drain plug by hand.
Caution:
Engine oil can be "hot".
5.
Collect old oil in a suitable container and dispose of in
accordance with the environmental regulations.
Fig. 42
6.
Check oil drain plug (1) for damage and replace if necessary.
7.
Always replace the copper seal (2).
8.
Screw in oil drain plug by hand and tighten (e.g with ring
spanner SW 13).
Tightening torque: 12 Nm
Fig. 43
9.
Release oil filler cap (3) e.g. with a jaw spanner SW 13 and
screw off by hand.
10. Fill with engine oil.
11. Only tighten the oil filler cap (3) by hand (risk of breakage).
12. Start engine and check for leaks.