Ferm DHM-1100 User Manual - page 5
Ferm
05
•
Do not touch the bit or parts close to the bit immediately after operation; they may be
extremely hot and could burn your skin.
When chipping into walls, floors or wherever “live” electrical wire may be
encountered, do not touch any metal parts of the tool!
Electrical safety
Always check that the mains voltage is the same as on the type plate of the
machine.
The machine is double insulated compliant with EN50144; therefore, no earth
connection is required.
Replacement of power cords or plugs
Immediately dispose of old cords and plugs once they have been replaced. It is dangerous to
plug a loose power cord into a mains power socket.
Use of extension leads
Only ever use approved extension leads that are suitable for the power rating of the machine.
The minimum core thickness is 1.5 mm
2
. Whenever using a reel extension lead, always fully
unroll the lead.
3. ASSEMBLY
Mounting tool bits
Fig. 3
Before exchanging a bit, first remove the power plug from the mains.
•
Lightly oil the bit shaft before inserting it into the tool holder.
•
Rotate the stop lever 180º clockwise, while pulling it towards you
•
Insert the tool shank into the hexagonal tool holder: the flat side of the bit towards the side
of the stop lever.
•
Rotate the stop lever 180º counterclockwise to lock the bit.
Auxiliary handle
The auxiliary handle can be adjusted to several positions to have a good control to the tool.
•
Loosen the handgrip of the auxiliary handle by turning it counterclockwise.
•
Place the auxiliary handle in the desired position.
•
Tighten the handle by turning it clockwise again.
UK
16
Ferm
L’emballage est autant que possible constitué de matériau recyclable. Veuillez par
conséquent destiner cet emballage au recyclage.
Tout équipement électronique ou électrique défectueux dont vous seriez
débarrassé doit être déposé aux points de recyclage appropriés.
Garantie
Pour les conditions de garantie, veuillez consulter la carte de garantie.
CE DÉCLARATION DE CONFORMITÉ (F)
Nous declarons sous notre propre responsabilité que ce produit est en conformité avec les
normes ou documents normalisés suivants
EN50144-1, EN50144-2-6, EN55014-1, EN55014-2, EN61000-3-2, EN61000-3-3
conforme aux réglementations:
98/37/CEE, 73/23/CEE, 89/336/CEE, 2000/14/CEE
dès 01-11-2005
ZWOLLE NL
W. Kamphof
Quality department
C’est notre politique d’améliorer continuellement nos produits et par conséquent de réserver
le droit de changer les instructions des produits sans un avis antérieur.
Ferm BV • Lingenstraat 6 • 8028 PM Zwolle • Hollande
F