FG Wilson DCP-10 User Manual - page 27
DCP-10
Page 23/27
9. LCD Display and Menu System
Using a backlit TN type LCD to display data and information. After pressing any push button the
backlight will automatically turn off in a preset time. In normal operating status, you can set the page
scroll time to circularly display each page of measuring data. Press “
” manually scrolls to view each
measuring data. When failure occurs, LCD displays the corresponding failure icon.
Press and hold “
” button 2sec to enter into parameters setting menu, then use “ ” or “
” to scroll
page, press “
” again to select the required modify item, press “ ” or “
”, LCD displays
0 0 0 0
when
prompted to enter password, then use “ ” or “
” to modify the first digital value, press “
” move to
modify the next one, after this, the first digital value will be displayed as “H”. Press “
” to confirm after
the password is set as 2213, then you can modify parameters. Otherwise it will prompt to key in
password again. Press and hold “
” for more than 2sec to quit parameters setting mode after finishing
configuration.
9.1 Static LCD displays
Controller is in standby status, circularly displays each measuring data:
→
→
→
→
Controller is normally running, circularly displays each measuring data:
→
→
→
→
→
→
→
→
→
→
→
→
→
→
→
→
NOTE:
When T-sensor or P-sensor is set as “not used”, LCD will not display related
measuring data.