FratelliOnofri FREV905D Owner's Manual And Installation Instructions - Warning!
Changing the rear oven lamp:
1. electrically disconnect the oven.
2. after the oven has cooled down, unscrew
(anticlockwise) the lamp cover.
3. Change the lampe (see note).
4. Refit the lamp cover.
5. Electrically reconnect the oven.
NB: Only use 25 W 110 V lamps type E-14,
T300°C, available from our After-Sales-Service.
Important: Do not use the oven without refitting
the lamp cover.
19
Operating Instructions
Care and Cleaning
Inst
allation Instructions
Troubleshooting
Tips
Safety Instructions
CARE AND CLEANING OF THE RANGE
Be sure electrical power is off and all surfaces are cool before cleaning any part of the range.
Proper care and cleaning are important so your range will give you efficient and satisfactory service.
Follow these directions carefully in caring for your range to assure safe and proper maintenance.
If your range is removed for cleaning, servicing or any reason,
be sure the anti-tip bracket are inserted properly in the slots of
the range when it is re-placed. Failure to take this precaution
could result in tipping of the range and cause injury.
If the gas line has been disconnected, check for
gas leaks after re-connection with a liquid leak
detector at all joints and connections.
NOTE: A trained technician should make the gas
installation, disconnection and re-connection of
the gas supply to the appliance.
How to Remove the Range for Cleaning and
Servicing
Follow these steps to remove the range for servicing
or cleaning hard to reach surfaces.
1) Shut off the gas supply to the range.
2) Disconnect the electrical supply to the range.
3) Disconnect the gas supply tubing to the range.
4) Slide the range forward.
Metal Parts
Do not use steel wool, abrasives, ammonia or commercial oven cleaners.
To safely clean surfaces: wash, rinse and then dry with a soft cloth.
Painted Surfaces (on some models)
Painted surfaces include the sides, control panel, door and kick panel.
Clean these with soap and water or vinegar and water solution.
Do not use commercial oven cleaners, cleansing powders, steel wool or harsh abrasives on any painted
surface.
WARNING!
5) Reverse these steps to re-install the range.
See the Installation Instructions for the location of
the bracket (see anti-tip bracket installations).
Control Panel and Knobs
Its a good idea to wipe the control panel after each
use of the oven. Clean with mild soap and water
or vinegar and water, rinse with clean water and
polish dry with a soft cloth.
Do not use abrasive cleansers, strong liquid
cleaners, plastic scouring pads or oven cleaners
on the control panel. They will damage the finish.
A 50/50 solution of vinegar and hot water works
well.
The control knobs may be removed for easier
cleaning.
To remove the knob, pull it straight off the stem.
Wash the knobs in soap and water or a vinegar
and hot water solution but do not soak