Gaggenau CV 282 Instruction Manual - page 14
14
en
Twist-Pad with Twist knob
j
Twist-Pad with Twist knob
Twist-Pad with Twist
knob
The twistpad is the control panel where you can use the
twist knob to select the hotplates and heat settings.
The twist knob is magnetic and is placed in the middle
of the area marked on the twistpad. To activate a
hotplate, press the twist knob so that it tilts in the
appropriate area for the required hotplate. Turning the
twist knob selects the heat setting.
Position the twist knob on the twist pad so that it is in
the centre of the indicators which delimit the twist pad
area.
Note: Even if the twist knob is not entirely central, this
will not affect how the twist knob works.
Removing the twist knob
Removing the twist knob activates the wipe protection
function.
The twist knob can be removed during cooking. The
wipe protection function is activated for 10 minutes. If
the twist knob is not returned to its position before this
time elapses, the hob will switch off.
m
Warning – Risk of fire!
If a metallic object is placed in the twist pad area during
these 10 minutes, the hob may continue to heat up. For
this reason, always switch off the hob using the main
switch.
Storing the twist knob
A strong magnet is located inside of the twist knob.
Keep the twist knob away from magnetic data carriers
such as credit cards and cards with magnetic strips.
Otherwise, these data carriers may be damaged beyond
repair.
The magnet may also cause faults on televisions and
screens.
Note: The twist knob is magnetic. Metal particles stuck
to the bottom may scratch the surface of the hob.
Always clean the twist knob thoroughly.
1
Operating the appliance
Operating the appliance
This chapter explains how to set a hotplate. The table
shows heat settings and cooking times for various
meals.
m
Warning – Risk of burns!
The filter cover made from cast iron is very hot on the
hob. Never place the filter cover on the hob. Do not
place pots, pans or other hot objects on the filter cover.
Note: Switch on the ventilation system when you start
cooking and switch it off again a few minutes after you
have finished cooking. This is the most effective way of
removing steam from the kitchen.
Note: Never use the appliance without the container,
metal grease filter or filter cover.
Switching the hob on and off
Switch the hob on and off using the main switch.
To switch on: Position the twist knob on the control
panel. Touch the
#
symbol. The symbols for the
hotplates and the functions available at this time light
up.
‹
lights up next to the hotplates. The hob is ready
for use.
To switch off: Touch the
#
symbol until the display
goes out. All hotplates are switched off. The residual
heat indicator remains lit until the hotplates have cooled
down sufficiently.
Notes
–
The hob will switch itself off automatically if all the
hotplates have been switched off for more than 20
seconds and the ventilation system is switched off.
–
The selected settings are stored for 5 seconds after
the hob has been switched off.
If the hob is switched back on during this time, the
heat settings that were previously set will flash. To
apply these settings, tap on the twist knob within
the next 5 seconds.
If you do not tap the twist knob or you touch a
different sensor button, all the previous settings will
be deleted.
Setting a hotplate
Set the required hotplate using the twist knob.
Heat setting 1 = lowest setting.
Heat setting 9 = highest setting.
Every heat setting has an intermediate setting. This is
shown in the hotplate display as .5.