Gaggenau CV 282 Instruction Manual - page 40
40
en
Cookware test
Cookware test
Cookware test
This function can be used to check the speed and
quality of the cooking process depending on the
cookware.
The result is a reference value and depends on the
properties of the cookware and the hotplate being used.
1
With the cookware still cold, fill it with approx.
200 ml of water and place it on the centre of the
hotplate with the diameter that most closely
matches that of the base of the cookware.
2
Go to the basic settings and select the
™ˆ
setting.
3
Touch the control panel.
A
will flash on the hotplate
display.
The function has now been activated.
After 10 seconds, the result for the quality and speed of
the cooking process will appear in the hotplate display.
Check the result using the following table:
To reactivate this function, touch the settings range.
Notes
–
If the diameter of the hotplate used is much smaller
than the diameter of the cookware, it is likely that
only the middle of the cookware will heat up. This
may result in the cooking results not being as good
as expected or being less than satisfactory.
–
You can find information on this function in the
section entitled
–
You can find information on the type, size and
positioning of the cookware in the section entitled
~
"Induction cooking"
D
Cleaning
Cleaning
m
Warning – Risk of burns!
The appliance becomes hot during operation. Allow the
appliance to cool down before cleaning.
m
Warning – Risk of burns!
The appliance will become hot during operation. If hot
liquids penetrate the appliance, leave the appliance to
cool for at least two hours before removing the filter
cover, the metal grease filter, the container, the overflow
reservoir or the appliance housing.
m
Warning – Risk of electric shock!
Do not use any high-pressure cleaners or steam
cleaners, which can result in an electric shock.
m
Warning – Risk of electric shock!
Penetrating moisture may result in an electric shock.
Clean the appliance using a damp cloth only. Before
cleaning, pull out the mains plug or switch off the circuit
breaker in the fuse box.
m
Warning – Risk of injury!
Components inside the appliance may have sharp
edges. Wear protective gloves.
Note: Only use a minimal amount of water when
cleaning so that no water enters the appliance.
Notes
–
Before cleaning the appliance, remove any jewellery
you are wearing on your arms and hands.
–
Do not use any cleaning agents while the hob is still
hot. This may mark the surface. Ensure that any
residue left by cleaning agents is removed.
Cleaning agents
Only use cleaning products that are suitable for this
type of hob. Follow the manufacturer's instructions on
the product packaging.
Follow all instructions and warnings included with the
cleaning products.
Suitable maintenance and cleaning products can be
purchased from the after-sales service or in our e-Shop.
Caution!
Beware of causing surface damage
Do not use:
–
Undiluted washing-up liquid
–
Cleaning products designed for dishwashers
–
Abrasive cleaning products
–
Pressure washers or steam jet cleaners
–
Oven cleaners
Result
‹
The cookware is not suitable for the hotplate and will
therefore not heat up.*
‚
The cookware is taking longer to heat up than expected
and the cooking process is not going as well as it
should.*
ƒ
The cookware is heating up correctly and the cooking
process is going well.
* If there is a smaller hotplate available, test the cookware
again on the smaller hotplate.
X|
É
Y|
[|
\|
Z|