Gaggenau ED 220-6 Series Instruction Manual - page 12
12
3.1 Overview
The required moisture level and temperature
can be set before and after time programming by
turning the “Temperature” or “moisture level” knob.
As long as one or several symbol(s) in the
display flash(es), an input is possible. The
flashing means that a value has not been program-
med or that the value programmed is not a valid
one.
All time values are entered by means of the
(Timer), +, – and
(Confirm) keys. Every input
triggers an audible and visible signal.
The longer you press the + or – key when
programming a time, the faster the time elapses on
the display.
Press the
(Confirmation) key if you wish to
confirm a value during programming. If you
press any other key instead, the entered value
will not be stored and will disappear.
An entered value (exception: short time) must
be confirmed with the
(Confirmation) key within
20 seconds as otherwise the entered value will
not be stored and the current time of the day will
appear on the display.
If you enter a time value in the short time
function mode, the set time will begin to expire
immediately without confirmation.
You can query set values by pressing the
(timer) key. The value appears on the display for
a few seconds. During this time, you can modify
the value by pressing the + or – key and you can
confirm it by pressing the
(Confirmation) key.
Press the + and – keys at the same time if you wish
to clear a value.
After completion of time programming, the
corresponding symbol flashes on the display. For
example, if you have programmed an end time, the
(end time) symbol will flash. An audible signal is
also sounded. Heating is deactivated and the oven
lighting goes off. You can restart the cooking by
pressing any key on the display. You end the baking
process by turning the “Temperature” knob to 0.
Every alarm goes off after 3 minutes.
Turn the “Temperature” control knob back to 0
to switch over from the automatic mode to the
normal mode of operation. The steam oven will then
no longer heat. The previously programmed value
is retained. An audible signal sounds after the
entered time has elapsed.
If the water has not been connected properly,
the
(Tap) symbol will light up in the display and
the appliance cannot be operated.
All functions are disabled if the appliance has
never been calibrated.
3. Operation