Gaggenau ED 220-6 Series Instruction Manual - page 6
6
1.3 About use
The appliance is intended solely for use in the
household and must not be put to any other uses.
Use the appliance to prepare meals only. It must not
be used to heat up the room in which it is installed.
Only ever use the included cooking inserts or order
the special accessories.
Do not place any items in the oven compartment
that might rust. Rusty accessories will lead to
further rusting in the oven compartment!
Do not use any silver cutlery in the cooking
compartment.
The cooking compartment may become
discoloured during prolonged operation. This does
not have a detrimental influence on operability of
the appliance.
Operation is only possible when the door is
closed, otherwise there is a risk that water will
spray out of the appliance or that hot steam will
come out.
The
(Heating) symbol in the control panel goes
off as soon as the required temperature has been
reached.
Turn the “Temperature” control knob to the 0
position after use.
In the event of malfunctions, first of all check
the household fuses. If the problem has nothing to
do with the power or water supply, please contact
your specialist dealer or your local Gaggenau after-
sales service.
Steam may escape during operation and when
opening the door. Water may drip when opening
the door. To prevent extreme steam from escaping
when you open the door, you can condense
beforehand.
The door window may fog up at all moisture levels
(above all at the 100% moisture level).
Operating noise may occur in all operating
modes. Opening and closing of the air flap causes
a clicking noise.
Observe caution when taking out cooking
receptacles. Risk of burns!
The appliance rinses automatically if it has not
been in operation for a prolonged period of
time or after a prolonged power failure (several
hours). This removes water that is left over in the
pipes.
The food being cooked must not come into
contact with the sides or the grease filter.
At set temperatures below 65 °C / 150 °F, the light is
switched off after a few seconds to ensure that
the halogen lamp will not additionally heat
up the oven compartment. This ensures more
precise temperature coordination. The light in the
oven compartment is switched on again for a few
seconds if you turn one of the two control knobs or
if you press a key.
The appliance cannot be operated if it has not
been calibrated!
Automatic self-adjustment (calibration):
The boiling point of water depends on the baro-
metric pressure. The barometric pressure changes
with the altitude of the. place where the appliance
is installed. During self-adjustment, the appliance
adapts itself to the pressure conditions prevailing at
the appliance’s location.
The appliance features a descaling display.
When it flashes, this is an indication that the
appliance must be descaled. Before commencing
operation, you must enter the water hardness in
your household on the appliance.