Gaggenau ED 220-6 Series Instruction Manual - page 36
8.1 Technical data
Heating power
Hot air heating element 2700 W
Max. water pressure 500kPa (5 bar)
Technical modifications without notice.
8.2 Installation notes
Pay attention to Chapter 1 (Important notes).
The appliance must only be connected by an
authorised specialist, paying attention to the
relevant regulations of the power supply companies
and the regional construction regulations.
Pay attention to the maximum water pressure!
Measure the water pressure or inquire with your
local authority about the water pressure. Use the
correct connection set!
The installing technician is responsible for the
correct functioning of the appliance at the time of
installation. He must instruct the user on how to
operate the appliance correctly on the basis of
the Operating Instructions, and the user must be
instructed on how to disconnect the appliance in
an emergency.
We accept no liability for damage caused by
failure to comply with these instructions.
The appliance must be deenergised in the event
of repairs or in an emergency.
Repairs and maintenance work must be carried
out by trained after-sales technicians.
Isolate the appliance from the electric and water
mains during every maintenance operation.
To do this, remove the mains plug or actuate the
corresponding fuse and turn off the tap.
Electrical connection conditions and water
connection information on the rating plate must
agree.
The wiring schematic that is adhered to the top of
the appliance shows the connection variant again.
Do not use any extension leads!
The electrical safety of the appliance is
guaranteed only if the earthing system belonging to
the domestic installation is installed in accordance
with regulations.
The manufacturer is not liable for damage that
might arise as the result of improper or non-existent
earthing of the appliance.
Connection to the power mains
On the top of the appliance there is a cover that
has to be unscrewed. The wiring diagram stuck
onto the top of the appliance shows the connection
variant.
The power mains to which the oven is to be
connected is fused with 16 A in each phase.
The appliance must be earthed.
The manufacturer cannot be held liable for
damages that might arise from improper or non-
existent earthing of the appliance.
Screw the cover back on.
For installation in Canada only:
When you install the appliance you need a special
fuse-box with circuit breakers which have to be
connected between the appliance and the socket.
When installing the fuse box and circuit breakers
please make sure that you have installed the right
breakers in each circuit. Please contact your dealer
or an electrician.
Follow the information on the enclosed wiring
diagram for connection details.
36
8. Assembly instructions
ED 220-6..
FD xxxx
AC 208/220-240V
60Hz 2900W
M 36W
M 24W
60W
16A