Gallet FMOEGH 233S Instruction Manual - page 71
ENG
71/ 92
70
Menu
Display
weight (g)
Power
A5
Meat
AUTO
COOK
AUTO
COOK
200
100 % (Mic.)
300
100 % (Mic.)
400
100 % (Mic.)
500
100 % (Mic.)
A6
Fish
AUTO
COOK
AUTO
COOK
200
80 % (Mic.)
300
80 % (Mic.)
400
80 % (Mic.)
500
80 % (Mic.)
A7
Pizza
AUTO
COOK
AUTO
COOK
300
100 % (Mic.) / 100 %
(Gri.)
400
100 % (Mic.) / 100 %
(Gri.)
A8
Bread
AUTO
COOK
50
100 % (Gri.)
100
100 % (Gri.)
A9
Roast
Chicken
AUTO
COOK
AUTO
COOK
750
C-2
1000
C-2
1250
C-2
A10 Cake
AUTO
COOK
475
Preheat at 160
degrees first.
XI. CLEANING
Disconnect the appliance from the el. outlet by pulling the fork of the supply cord from the
socket before maintenance! Keep the inner surfaces of the MW clean and dry in order that no
sediments of grease and food particles occurs. Clean the stainless surfaces with agents intended
for it. Do not use high-pressure or steam cleaners to clean! Make sure no water gets inside the
oven! In general the MW oven should be cleaned every time it has been used.
Inner walls
Remove all remains of food between door and MW oven with a damp cloth. This area must be
cleaned very thoroughly in order that the door can be closed properly. Remove all grease stains
with a damp cloth then wipe and dry the walls. Do not use cleaning agents which are rough and
abrasive because they will scratch and damage the surface of the MW oven. Remove the smells
from the inside of the oven by placing a microwaveable dish with water with lemon juice squeezed
from one lemon with skin and letting the microwaves work on it. Wipe and dry the inside of the
oven afterwards.
ATTENTION: Never pour water into the Mw oven!
Door
Door and door sealing must remain clean. Wash only with warm water with soap and then
dry thoroughly. Do not use any abrasive agents such as cleaning powders or metal or plastic
scrapers. Metal parts are best maintained by wiping them frequently with a damp cloth.
Outer parts
Clean outer casing with a fine cloth with warm water, then dry it with a soft cloth. Make sure that
water does not get to the inner parts. If the supply cord gets dirty, wipe it with clean cloth.
Always make sure that the surface of the door sealing is clean.