Garador Garage Door Opener Instruction Manual - page 13
©Copyright 2006
Garador
P/N: 05xxx
- 13 -
PROGRAMMING THE OPENER
Step 8
- REMOTE CONTROL TRANSMITTER
CODE SETTING
The garage door opener can only operate from remote
control transmitters that have been programmed into the
opener’s receiver. The receiver needs to learn the codes
of any remote control transmitter that will be used with the
operator. Up to 14 codes can be stored in the receivers
memory.
•
Up to
12
“Smart Code” remote control transmitters.
After 12 codes have been stored, any additional code
stored will cause the oldest code to be erased.
•
One
“dip-switch” remote control transmitter code.
Note: Programming a different dip-switch code will
automatically erase any previously programmed dip-
switch code, and
•
One
“entry keypad” code. Programming a different entry
keypad code will automatically erase any previously
programmed entry keypad code.
8.1 - Code Setting The Receiver With Smart
Code, Manual Release Or Dip Switch
Transmitters
1. Make sure that the battery is set in the
Transmitter.
2. Press the Code Set button on the opener, the
Code Set LED will illuminate to indicate the
opener is in Code Learn mode. If a valid code is
not stored within 15 seconds the opener will exit
Code learn.
3. Smart Code Transmitter
– Press and hold the
remote control transmitter button to be
programmed until the Code Set LED flashes to
indicate that it has been learnt.
Dip Switch Transmitter
– Select your dip switch
combination of switches by sliding them on or off,
now press and hold the remote control transmitter
button to be programmed until the Code Set LED
flashes to indicate that it has been learnt.
4. Release the button on the remote control
transmitter – the code is set.
Fig. 13
8.2 - Code Setting The Receiver With Entry
Key Pad Transmitter
1. Make sure that the battery is set in the Key
Pad Transmitter.
2. Press the Code Set button on the opener, the
Code Set LED will illuminate to indicate the
opener is in Code Learn mode. (if a valid code
is not stored within 15 seconds, the opener will
exit Code Learn).
3. For an entry keypad the desired code should
be typed (a minimum of four numbers or
letters) and the ENTER button held down until
the Code Set LED flashes to indicate that it
has been learnt.
4. Release the button on the remote control
transmitter – the code is set.
Fig. 20