Garador Garage Door Opener Instruction Manual - page 16
©Copyright 2006
Garador
P/N: 05xxx
- 16 -
SPECIAL FEATURES
10.5 - Code Setting “PET MODE”
The opener can be programmed into a “Pet Mode” where
the door opens approximately 200mm to allow pet to enter/
exit the garage:
1. Press Code Set button five times, the Code
Set LED will illuminate and the courtesy light
will flash quickly (twice per second) to show
that you are learning the code to operate the
“Pet Mode.
2. Choose a button on the remote control
transmitter that is not coded into the receiver,
press this button whilst in Pet Mode learning
mode and the courtesy light will go out and the
Code Set LED will flash rapidly to indicate the
receiver has stored this code.
Note:
Door opening height is adjustable with the use of a
programmer.
10.6 - SETTING OPTIONAL REMOTE CONTROL
TRANSMITTER DIPSWITCH CODES.
Some remote control transmitters have a dip-switch facility.
Generally, dipswitches are used when several persons are
operating the same opener. The dip-switches must be set
to matching positions in all remotes used to activate the
opener.
•
Remove the battery cover.
•
Set switches in all remote controls to matching positions
(+, -, 0). Use a pen or screwdriver.
Replace covers and program this code.
10.7 - TO ERASE PROGRAMMED CODES.
If the Code Set
button is pressed and held on for 6 seconds, the LED will
blink rapidly for one second to indicate that all programmed
codes have been erased.
Fig. 16
Permanently fix the label warning against
entrapment and manual operation in a
prominent place or near any fixed controls
After installation, ensure that the mechanism
is properly adjusted and that the opener
reverses when the door contacts a 50mm
high object placed on the floor under the
garage door – see Testing The Safety
System.
AS3350
Fig. 17