Garmin GMX 200 Installation Manual - page 42

Page 5-8 

GMX 200 Installation Manual 

Revision D 

190-00607-04 

2.

Press the 

Next Page

 line select key to view additional data source selections. 

a.

Lightning Source:  

Selections: None, Port 1, Port 2, Port 3, Port 4, Port 5

Select the port to which a lightning source is connected. 

NOTE 

Only one traffic source may be present (i.e. For UAT Source, Ryan 

TCAD Source Traffic Source (429) and Transponder TIS Source, only 

one may be configured for an external data source – the others must be 

set to 

None

.) 

b.

UAT Source:

Selections: None, Port 1, Port 2, Port 3, Port 4, Port 5

Select the port to which a UAT is connected. 

c.

Ryan TCAD Source:

Selections: None, Port 1, Port 2, Port 3, Port 4, Port 5

Select the port to which a Ryan TCAD is connected.  

d.

Traffic Source (429):

Selections: None, TAS, TAS+Disp

Select the port to which an ARINC 429 traffic source is connected.  If the GMX 200 is wired 

to drive the traffic system discrete inputs and control the traffic system, select the TAS option.  

If the GMX 200 is not wired to drive the discrete inputs (e.g.  when an additional traffic 

display such as the WX1000 is being used), select the TAS+DISP option.  Using the 

TAS+DISP option indicates that an external display is responsible for driving the discrete 

inputs and the corresponding GMX 200 controls will be disabled on the GMX 200 Traffic 

page.  

e.

Transponder TIS Source:

Selections: None, GTX 330

Select the type of TIS source that is connected.  

Select GTX330 if a GTX 33 is connected to the GMX 200.