Garmin GPSMAP 400 series Installation Instructions Manual
Installing the Flush Mount Kit
Use this kit to flush mount a Fishfinder 400C or GPSMAP 400 series unit into a flat panel.
• Select an appropriately sized location for the unit.
• Use the Flush Mount Template provided to determine a location.
• Check that all cables reach the unit mounting location.
• Always wear safety goggles and a dust mask when drilling, cutting, or sanding.
Included mounting hardware—(1) unit housing, (2) tension mount brackets, (4) hex bolts, (4) hex nuts, (4) wing nuts,
and (4) Phillips head screws.
Tools (not included)—drill, 3/8
"
(6 mm) drill bit, jig saw, 9/32
"
(7 mm) wrench, and Phillips screwdriver.
To install the Quick Release Flush Mount Kit:
1. Cuttheopening:
• TapetheFlushMountTemplatetothemountinglocation.
• Usinga3/8"(6mm)drillbit,drillthepilotholesindicatedonthetemplatetobegincuttingthemountingsurface.
• Usingthejigsaw,cutthemountingsurfacealongtheinsideofthelineindicatedonthetemplate.Beverycarefulwhencuttingthis
hole,becausethereisonlyasmallamountofclearancebetweentheunithousingandthetensionmountarms.Cutslightlyinside
the indicated line and then sand or file the panel as needed to obtain the best fit.
2. Assemble the flush mount hardware (see Figure 1):
• Insertthe(4)hexboltsintotheunithousingsotheystickoutoftheback.
• Usethe(4)hexnutstosecurethehexboltstotheunithousing.Usingthe9/32”(7mm)wrench,tightenthenutswithout
overtightening.
• Slidetheunitintotheunithousing.
• Usingthe(4)Phillipsheadscrews,attachtheunithousingtotheunit.
• Connectthewiringharnesstotheunit(Thiscanbedoneafterstep3,ifpreferred).
Unit
Hex bolts
Hex nuts
Phillips head screws
Hex nuts
Hex bolts
Figure 1
April 2007
Part Number 190-00757-02 Rev. C
Printed in Taiwan
EN