Garmin MX20 Installation Manual - page 15
Introduction
MX20 Installation Manual
560-1025-09 Rev E
5
Table 1-1. Installation Package Contents
Part #
Description
Quantity
w/o GPS
424-0751
Quantity
w/ GPS
Quantity
w/ I/O
424-0753
Unit
430-0270-0( )
MX20 Multifunction Display with GPS
1
430-0270-5( )
MX20 Multifunction Display without GPS
1
430-0270-6( )
MX20 I/O Traffic Multifunction Display
1
430-0270-7( )
MX20 I/O Traffic/Radar Multifunction Display
1
MX20 Installation Kit
115-0007-00
GPS 1575 MHz 2:1 Splitter
1
162-1008
Right Angle Coax Plug
1
162-1060 TNC
Connector
3
162-1577**
37-Pin D-Sub
1
1
1
202-0001 Cable
Tie
4 4 4
204-0037 Edge
Grommet
6" 6" 6"
204-2100 Shoulder
Bushing
2
220-0637
6-32 Wing Nut
1
1
1
240-0615 #6
Washer
2 2 2
224-0404
4-40 X 1/4 SS Flat Head Phillips Machine Screw
2
2
2
245-0027**
Crimp Contact For D-Sub, 20 To 24 AWG Wire
30
30
40
310-0429-( )
MFD Mounting Tube
1
1
1
998-0048
3/32" Hex Driver
1
1
1
MX20 I/O Installation Kit
160-0138
62-Pin D-Sub, High Density
1
245-0059
Crimp Contact For High Density D-Sub, 22 To 30 AWG Wire
20
564-0076-0( )
Manual Kit
1 1 1
140-0059-0( )
MX20 & i-linc MFDs Product CD
1
1
1
560-1025-( )
MX20 Installation Manual
0*
0*
0*
560-1026-( )
MX20 Pilot’s Guide
1*
1*
1*
561-0263
MX20 Quick Reference Guide
1*
1*
1*
564-0078-0( )
Or
560-1055-0( )
STC Kit (AFMS & MDL)
Or
STC Index (AFMS, RFMS, MDL, STC, AML, etc.)
0* 0* 0*
Notes:
* These documents are currently included in the product CD.
** Pin has a barrel over the contact. Use ITT Cannon tools.
Other Required Materials
The MX20 equipment is intended for use with standard aviation accessories. See Section 2.3.1 for a list
of compatible equipment. The following items are required for the installation:
Compatible position locating source, such as: GX50/55/60/65 GPS receiver, or CNX-series (or
GNS 480) receiver
Compatible Serial Altitude Encoder
Sixteen AN507 or MS24693 6-32 cadmium-plated carbon steel screws with 100
º
countersink flat
heads to secure the mounting tube to the aircraft structure.