Hadex Megapixel IP Camera User Manual - page 16
Megapixel IP Camera User manual V2.0.0
26
lose and can’t restoration, so if there is some important date you’d better transfer it to
other place.
Figure 4.3 if ensure to format storage device?
4.2 Storage setting
4.2.1 Basic Setup
The basic setup of storage setting is as figure 4.4.
Figure 4.4 basic setup
Local Storage: here must set “enable” then the device can record and snap.
Storage Strategy: the treatment when the storage space is not enough. It has two
choices: shop record when the storage space is full or overwrite the old record when it
full.
Storage media: to select the storage order of storage devices. A camera could connect
three storage devices at all, they are SD1, SD2 and USB, so there are seven choices
include the choice of auto select. You can select the order by yourself.
Max Time each file: when the configuration is schedule record, it refers to the record
time of each record file. There are three choices. To limit record time can avoid too
large record may open slowly or can not playback.
4.2.2 Motion Alarm Record
The setting of motion alarm record is as figure 4.5. Once enable this function, when
there is motion alarm, the device will record according to the configuration.
Megapixel IP Camera User manual V2.0.0
27
Figure 4.5 motion alarm record
Motion alarm record: only when it enables others parameters can be changed.
Video stream: there are two choices “Main Stream” and “Sub Stream”. Main stream
has clearer stream, but record same time needs more storage space, so you can choice
by your needing.
Video format: you can just choose AVI.
Media type: “Audio and Video” means the record file you will get with sound, so
video without sound. But this not means that you choose “Audio and video”, you will
get record file with sound. The premise is that your camera with the function of audio
and there is audio input, moreover, the camera has enable the function of audio
encode.
Prerecord time: before start record, camera saves date in temporary buffer, once start
record, then call those dates, this is the function of pre-record. The most prerecord
time our camera supports is 5 seconds.
Record time: time of a record file, range from 10 seconds to 600 seconds.
Upload to FTP: when you have right configured parameter of FTP, enable this
function, when end record, camera will send this record file to server.
Send to Email: when you have right configured parameter of SMTP, enable this
function, when end record, camera will send this record to the mailbox.
4.2.3 Motion Alarm Snap
When there is motion alarm, if the storage space is not enough or you need not record,
but you need know what cause this alarm, you can choose the function of motion
alarm snap. Enable this function, when there is motion alarm, camera will snap
picture according to the configuration.