Hadex Megapixel IP Camera User Manual - page 19
Megapixel IP Camera User manual V2.0.0
32
5 Alarm
5.1 Motion Alarm
The setting of motion alarm is as figure 5.1.
Figure 5.1 motion alarm
Motion alarm: only when it enables others parameters can be changed.
Sensitivity: the sensitivity of motion detection. The value is larger and more easily to
create alarm.
Alarm threshold: to measure whether create alarm or not when the video changes. The
value is smaller and more easily to create alarm.
Black count: to select the way to divide video. After divided, just the video change in
the area that surrounded by red box will create motion alarm.
Enable night time: when the camera is working, maybe to the same video change, it
needs different result in different time, this can be achieved by the function of “Enable
night time”. Once enable it, during the setting time, night parameter makes function.
If there is a conflict between standard time and night time, night parameter is first.
Night start time: the start time that night parameter makes function.
Night end time: the end time that night parameter makes function.
Night sensitivity: the sensitivity of night parameter.
Night alarm threshold: the alarm threshold of night parameter.
After set related parameter of motion detection, you need set alarm time, this function
can be achieved by motion detect alarm schedule, as figure 5.2.
Megapixel IP Camera User manual V2.0.0
33
Figure 5.2 motion detect alarm schedule
The period number is auto create. A period consists of date, start time and end time.
After set an alarm time, click the button of “Add”, then this alarm time will show in
below list. A camera can add twenty-four alarm time most. The time among different
period can not conflict, or can’t add successfully, as figure 5.3. You can’t modify a
period, when the added time has question, you can delete it and add a new period. The
deleting step is click this period, right-click the mouse, then come out an option of
“Delete”, click it.
Figure 5.3 time conflict
Alarm output is another way for alarm. Enable “alarm output” and connect external
device for output such as speaker, flash lamp Etc, to tell surveillance person that there
is a motion alarm. Parameters you need to set as follows: enable alarm output or not,
alarm output port, alarm output type and alarm duration. After set those parameters,
click the button of “Save”, the setting will make function.
Figure 5.4 alarm output
5.2 Video Lost Alarm
Too many reasons can cause video lost, such as disconnect video cable. In this case,
we can enable “Video Lost alarm” for reminding.
At the same time, many parameters need to be configured, as figure 5.5. Alarm output
is another way for reminding “Video lost”. But you need to enable it and configure