HAI OmniTouch 10p User Manual - Installing The Battery
Chapter 2
Getting Started
This chapter explains how to install and charge the battery, how to check battery status, how to
turn on the OmniTouch 10p, and how to calibrate the screen.
Installing the Battery
This section explains how to install the battery.
WARNING! There is a risk of fire and burns if the battery pack is handled improperly.
DO NOT disassemble, crush, puncture, short external contacts, or dispose the battery
pack in fire or water. DO NOT attempt to open or service the battery pack. Dispose of
used batteries according to local recycling guidelines in your area.
CAUTION! The battery used in this device may present a risk of fire or chemical burn
if mistreated. Do no disassemble, heat above 60°C, or incinerate. Replace battery with
HAI P/N: 67A03-1 (46-12427-041) only. Use of another battery may present a risk of fire
or explosion.
1. Lift the stand out of the way.
2. Remove the four screws that secure the battery compartment cover to the chassis.
9