Home Automation 12A00 Installation Manual - page 13
11
CONNECTING TO OMNIPRO
Connect the "A" & "B" terminals of the 12A00 to the "A" & "B" terminals under the section
marked "Consoles" on the OmniPro controller. Connect the "+12" and "GND" terminals of the
12A00 to the "AUXILIARY 12V" and "AUXILIARY GND" terminals on the OmniPro,
respectively.
OmniPro Controller
12A00 Wireless Receiver
OMNIPRO SETUP
A. When connected to an OmniPro, the 12A00 is recognized as an Expansion Enclosure. The
12A00 can handle up to 64 wireless zones, in groups of 16. Each group of 16 zones is
considered 1 Expansion Enclosure.
B. On the OmniPro console, enter the “Installer Setup” menu (press 9, installer code, then #).
Press 2 for “Zones”. Press the down arrow once, then enter the number of expansion
enclosures (groups of 16 wireless zones) being used.
C. The wireless zones on the OmniPro start on zone 33 (if no hardwire expansion enclosures are
used).
D. The 12A00 address is set at 1 (A1) (if no expansion enclosures are used).
E. If the OmniPro has 1 expansion enclosure, the wireless zones start on zone 49.
The 12A00 address is then set to 2 (A2).
F. If the OmniPro has 2 expansion enclosures, the wireless zones start on zone 65.
The 12A00 address is then set to 3 (A3).
G. If the OmniPro has 3 expansion enclosures, the wireless zones start on zone 81.
The 12A00 address in then set to 4 (A4).