Home Automation 12A00 Installation Manual - page 6
4
SETUP MODE
The Setup Mode is used to configure the general operating parameters of the receiver, to program a
transmitter into the receiver, and to change the characteristics of a programmed transmitter. The
Mode LED does not blink in Setup mode.
To enter the Setup mode:
A. Press and hold the Mode/Advance switch for approximately two seconds.
B. Enter the four-digit code. "C" is shown on the left of the display and the digit for each code
number is shown on the right of the display.
C. The Set switch is used to increment the value of the digit.
D. The Mode/Advance switch is used to advance to the next digit of the code. The Mode and
Type LED’s are used to indicate which digit of the code is shown.
When no LED is lit, enter the first digit of the code. When the Type LED is lit, enter the second
digit. When the Mode LED is lit, enter the third digit. When both the Type and Mode LED’s are
lit, enter the fourth digit. The default code is 1111. If the correct code is entered, you will be
allowed to enter Setup mode. The receiver will return to Run mode if the wrong code is entered or
if the Mode/Advance switch is pressed for two seconds prior to entering all the digits.
Use the Set switch to increment the first digit of the code.
C 1
Use the Set switch to increment the second digit of the code.
C 1.
Use the Set switch to increment the third digit of the code.
C.1
Use the Set switch to increment the fourth digit of the code.
C.1.
After entering the code you are prompted to enter the receiver address. "A" is shown on the left of
the display and the current address is shown on the right. Pressing the Set switch changes the
address. The current address will be stored into memory when the Mode/Advance switch is
pressed. Setup mode is exited when the Mode/Advance switch is pressed for two seconds.
Next, you are prompted to enter the number of addresses. The letter "n" is shown on the left of the
display and the digit for the current number of addresses is shown on the right of the display.
Pressing the Set switch changes the number of addresses. The current number of addresses will be
stored into memory when the Mode/Advance switch is pressed. Setup mode is exited when the
Mode/Advance switch is pressed for two seconds.
The next four items allow you to change each digit of your security code. The Set switch is used to
increment the value of each digit. The Mode/Advance switch is used to enter each digit and
advance to the next.