Home Automation 12A00 Installation Manual - page 8
6
TRANSMITTER SETUP
A. Press and hold the Mode/Advance button for two (2) seconds.
B. Enter the code (default 1111).
! To enter the first number of the code, press the SET button. "C1" will appear.
! Press the Mode/Advance button to advance to the next code number.
! Press the SET button. "C1." will appear (second number of the code).
! Press the Mode/Advance button to advance to the next code number.
! Press the SET button. "C.1" will appear (third number of the code).
! Press the Mode/Advance button to advance to the next code number.
! Press the SET button. "C.1." will appear (fourth number of the code).
C. "A1" will appear. On OmniLT and Omni, "A1" is always used. On the OmniPro system, the
address will depend on the number of expansion enclosures used. If none are used, then "A1"
will correspond (see "OmniPro Setup" for more information).
D. Press the Mode/Advance button to proceed and to save any changes.
E. Next, "n1" will appear. The value of "n" will determine the number of transmitters used.
F. Press the Mode/Advance button to proceed and to save any changes.
G. C1 will appear (the 1
st
number of the code). Pressing the SET button increments the number.
H. Press the Mode/Advance button to proceed.
I.
"C1." will appear (2
nd
number of the code). Pressing the SET button increments the number.
J.
Press the Mode/Advance button to proceed.
K. "C.1" will appear (3
rd
number of the code). Pressing the SET button increments the number.
L. Press the Mode/Advance button to proceed.
M. "C.1." will appear (4
th
number of the code). Pressing the SET button increments the number.
N. Press the Mode/Advance button to proceed.
O. "1" will appear (1
st
transmitter address). Trip the transmitter. When the 12A00 receives the
transmission, the 12A00 will display the digit (transmitter address) with a dot on either side
(the dots indicate the transmitter's characteristics).
P. Press the Mode/Advance button to proceed and to save the changes made.
Q. "2" will appear (2
nd
transmitter address). Trip the transmitter. When the 12A00 receives the
transmission, the 12A00 will display the digit (transmitter address) with a dot on either side
(the dots indicate the transmitter's characteristics).
R. Press the Mode/Advance button to proceed and to save the changes made.
S. Repeat for each transmitter address (1-64) until all transmitters have been programmed.