I-MO 520 Series Product Installation Manual - page 24
INSTALLATION MANUAL FOR THE EMS I-MO 540 SERIES APPLIANCE
Version
1.2
ELECTRONIC MEDIA SERVICES LIMITED
PASSFIELD BUSINESS CENTRE, LYNCHBOROUGH ROAD, LIPHOOK, HAMPSHIRE, GU30 7SB, UK
Tel: 01428 751655 | Fax: 01428 751654 | E-mail: imo@ems-uk.com
Page
24
of
58
This option is only valid if the i-MO has one or more Hard Drives installed that have been initialised with the
RAID command. See the following chapter for the command line utilities.
When the NAS is enabled a user on the local LAN can mount the public share.
Command Line Interface
The i-MO appliance has a command line interface (CLI) that can be accessed by logging in on the serial
console or via SSH from the local subnet. The username is admin and the default password is i-MO/admin.
It is strongly recommend that the default password is changed using the “passwd” command.
The CLI provides access to a number of standard Linux commands to view the system configuration and
logfiles. It also includes a number of standard network diagnostic tools including nslookup, ping, route and
traceroute.
The current running configuration file is located in /admin/config.
This folder also contains the following files:
• hostapd.accept
• hostapd.deny
• hostapd.wpa_psk
• hostapd.vlan
• hosts.allow
• hosts.deny
hostapd.accept
can contain a list of MAC address that should be allowed access to the WiFi Access Point:
# List of MAC addresses that are allowed to authenticate (IEEE 802.11)
# with the AP. Optional VLAN ID can be assigned for clients based on the
# MAC address.
00:11:22:33:44:55
00:66:77:88:99:aa
00:00:22:33:44:55