I-MO 520 Series Product Installation Manual - page 43
INSTALLATION MANUAL FOR THE EMS I-MO 540 SERIES APPLIANCE
Version
1.2
ELECTRONIC MEDIA SERVICES LIMITED
PASSFIELD BUSINESS CENTRE, LYNCHBOROUGH ROAD, LIPHOOK, HAMPSHIRE, GU30 7SB, UK
Tel: 01428 751655 | Fax: 01428 751654 | E-mail: imo@ems-uk.com
Page
43
of
58
eth1bridging="yes"
eth2enabled="yes"
eth2bridging="yes"
eth3enabled="yes"
eth3bridging="yes"
eth4enabled="yes"
eth4bridging="yes"
wlan0enabled="yes"
# Enable WiFi and add to bridge interface
wlan0bridging="yes"
wlan0wifissid="imo"
# Set SSID
wlan0wifiwpakey="12345678"
# Set WPA key – must be 8-63 characters long
wlan0wifichannel="manual"
# Only manual selection currently supported
wlan0wifichannelvalue="6"
# Set WiFi Channel 1-13, 1/6/11 preferred
wlan0wifirate="manual"
# Set maximum bandwidth
wlan0wifiratevalue="24"
wlan0wifi80211mode="g"
# Set WiFi 802.11b/g mode
eth5enabled="yes"
# Configure port 5 as WAN port
eth5bridging="no"
eth5firewallzone="external"
# Place in external zone
eth5ip="195.74.68.4/28"
# Set IP address/netmask
eth5dhcp="no"
[failover]
enabled="yes"
# Enable failover
routerrefresh="10"
# The failover router will be updated
# every “routerrefresh” seconds
routerperiod="31"
# If active link is unavailable for
# “routerperiod” seconds it will be
# marked unavailable and next failover
# link will become active
networks="default"
# Subnet to be routed to active failover link
link0device="eth5"
# Interface or link name for primary link
link1device="mob0"
# Interface or link name for secondary link
[tunneling]
enabled="no"
# Disable tunneling
[wan]
enabled="yes"
# Enable WAN router
wan0device="eth5"
# Device for this port
wan0gateway="195.74.68.1"
# Gateway address
wan0heartbeatrefresh="10"
# Status of the link will be checked
# every “heartbeatrefresh” seconds
wan0heartbeatperiod="30"
# If the heartbeat address is unavailable for
# “heartbeatperiod” seconds it will be
# marked as down
wan0hearbeataddress="8.8.8.8" # The address of the heart beat device
# This address must respond to ICMP pings
[mobilerouter]
enabled="yes"
# Enable the mobile router
mob0linkname="mob0"
# Link name for the cellular link
mob0heartbeatrefresh="20"
# Status of the link will be checked
# every “heartbeatrefresh” seconds