I-MO 520 Series Product Installation Manual - page 40
INSTALLATION MANUAL FOR THE EMS I-MO 540 SERIES APPLIANCE
Version
1.2
ELECTRONIC MEDIA SERVICES LIMITED
PASSFIELD BUSINESS CENTRE, LYNCHBOROUGH ROAD, LIPHOOK, HAMPSHIRE, GU30 7SB, UK
Tel: 01428 751655 | Fax: 01428 751654 | E-mail: imo@ems-uk.com
Page
40
of
58
The [mobilerouter] section sets the options for the router process that manages the available cellular connec-
tions. The status of a link is tested by sending an ICMP ping to the "heartbeataddress" which can be either a
fully qualified domain name or an IP address.
If a tunnelname and concentratoraddress is specified then a new tunnel will be created or the link added to
an existing tunnel if bonding is enabled on the tunnel.
The networks option will add a route to the given subnets on this interface. The value may either be “default”
or a CIDR.
[mobilerouter]
enabled="yes"
# Number of seconds between update
heartbeatrefresh="10"
# Number of seconds before an inactive link is disabled
heartbeatperiod="30"
mob0linkname="mob0"
# Override the default values for this link
mob0heartbeatrefresh="20"
mob0heartbeatperiod="50"
mob0hearbeataddress="1.2.3.4"
mob0concentratoraddress="1.2.3.4"
mob0tunnelname="tunnelname"
mob0networks="10.11.12.13/24"
mob1linkname="mob1"
mob1hearbeataddress="1.2.3.1"
mob1concentratoraddress="1.2.3.1"
mob1tunnelname="tunnelname"
mob1networks="10.11.12.14/24"
The [wan] section is used to configure any interfaces that are used for WAN links.
The wan router process is started when enabled is set to yes.
The device is the physical name of an interface, typically this will be one of the internal GbE ports.
The gateway option sets the nexthop for data sent via this interface.
The status of a link is tested by sending an ICMP ping to the "heartbeataddress" which can be either a fully
qualified domain name or an IP address. The link is checked every heartbeatrefresh seconds and if the link
is unresponsive for hearbeatperiod seconds then the port is marked as down.
If a tunnelname and concentratoraddress is specified then a new tunnel will be created or the link added to
an existing tunnel if bonding is enabled on the tunnel.
The networks option will add a route for the given subnet on this interface. The value may either be “default”
or a CIDR.
[wan]
enabled="yes"