I-SENS CareSens N Voice Manual - page 4
8 www.i-sens.com
www.caresens.co.nz 9
The CareSens N Meter comes with two 3.0 V lithium batteries.
Before using the meter, check the battery compartment and
insert batteries if empty.
When using your meter and seeing the
symbol appear on the
display for the first time, the batteries should be replaced as soon
as possible. The test results might not be saved if the batteries run
out.
PuttinginorReplacingtheBatteries
Step 1
Make sure the meter is turned off. Push the
cover in the direction of the arrow to open
the battery compartment.
Step 2
Remove the old batteries one by one by
lifting with the index finger and pulling it
out with your thumb and index fingers as
shown in the figure on the right. Insert two
new batteries with the + side facing up and
make sure the batteries are inserted firmly.
Step 3
Place the cover on the battery
compartment. Push down until you hear the
tab click into place.
Note:
Removing the meter batteries will not affect your
stored result. However, you may need to reset your meter
settings. See pages 14-16 .
Caring for Your System
Use a soft cloth or tissue to wipe the meter exterior. If necessary,
the soft cloth or tissue might be dipped in a small amount of
alcohol.
Do not use organic solvents such as benzene, or acetone, or
household and industrial cleaners that may cause irreparable
damage to the meter.
Caution:
• Donotexposethemetertodirectsunlightorheatforan
extended period of time.
• Donotletdirt,dust,blood,orwaterenterintothemeter’s
test strip port.
• Donotdropthemeterorsubmitittostrongshocks.
• Donottrytofixoralterthemeterinanyway.
• Keepthemeterawayfromstrongelectromagneticfields
such as cell phones and microwave ovens.
• CareSensNmetershouldbeusedonlywithCareSensN
strips.
• Keepthemeterinacoolandwellventilatedplace.
• Storeallthemetercomponentsintheportablecaseto
prevent loss.