I-SENS CareSens N Voice User Manual - page 19
38 www.i-sens.com
www.i-sens.com 39
Setting the Alarm Function
Step 1
Setting the PP2 Alarm On
Without inserting a test strip,
press and hold
for 3 seconds
to set the post-meal alarm. 'PP2',
the bell ( ) symbol and 'On'
will be displayed. The screen
will then automatically change
to the memory check mode. At
this time, the bell ( ) symbol,
indicating that the PP2 alarm has been set, will be displayed on
the screen.
Step 2
Setting the PP2 Alarm OFF
To turn off the PP2 alarm, press
and hold
for 3 seconds. 'PP2',
the bell ( )symbol,and‘OFF’will
appear on the screen. Then the
screen will change automatically
to the memory check mode
without the bell ( ) symbol
displayed.
Setting the Post-meal Alarm (PP2 alarm)
Four types of alarms can be set in the CareSens N Meter: one
post-meal alarm (PP2 alarm) and three time set alarms (alarm1-3).
The PP2 alarm goes off 2 hours after setting the alarm.
The alarms ring for 15 seconds and can be silenced by pressing
,
or the S button or by inserting a test strip.
symbol disappears
Step 1
Without inserting a test strip, press and
the S button simultaneously for 3 seconds
toenterthetimealarmmode.‘alarm1’
willbedisplayedwhile‘OFF’blinksonthe
screen.
Step 2
On pressing
,‘alarm1’issetand‘On’is
displayed on the screen. Press
again to
cancel 'alarm 1' and 'OFF' will blink on the
screen.
Step 3
Press toadjustthetimeof‘alarm1’.
A number representing the time will blink
on the screen. Press
to set the time.
Press to end.
Setting the Time Alarms (alarm 1-3)