Icom IC-F3262DS Operating Manual - Transmitting A Call
7
2
BIIS 1200 OPERATION
■
Transmitting a call
D General
• Editing an ID
If the transceiver has a key assigned to the TX Code Enter
function, you can edit an ID within the allowable digits.
Push
q
[TX Code Enter] to enter the ID edit mode.
• The digit to be edited blinks.
w
Push
[TX Code Enter] to select a desired digit to be ed-
ited.
e
Push
[CH UP] or [CH DOWN] to select a desired num-
ber.
Push
r
[TX Code Enter] to set. The digit to the right will
automatically blink.
Repeat step
t
e
and r to input all allowable digits.
After editing, push
y
[TX Code Enter] to store the setting.
• The transceiver returns to the standby mode.
NOTE: To overwrite the original ID, set the ‘Update’ item
to “Enable” using the CS-F3160/F5060 (dPMR)
cloning
software
. Otherwise, changing the channel or turning
OFF the transceiver discards the new ID, and returns the
original one. Ask your dealer for details.
D Transmitting an Individual or Group call
NOTE: If you want to make a call to the preprogrammed
ID, skip step q and w then directly go to step e.
Push
q
[BIIS Button] to enter the call code memory mode.
• The preprogrammed ID is displayed.
• “
” appears.
w
Push
[CH Up] or [CH Down] to select a desired Individual
ID or Group ID.
Push
e
[Call] to make a call.
• “
WAIT” appears while transmitting.
• “
CONNECT” is displayed when an acknowledgement is received.
NOTE: If no acknowledgement is received, the trans-
ceiver automatically repeats the call three times (de-
fault). However, when no acknowledgement is received
after each of the calls, an error beep sounds and
“
FAILED” is displayed. In that case, the transceiver au-
tomatically returns to the stand-by mode.
r
After “
CONNECT” is displayed, hold down [PTT] and
speak into the microphone at your normal voice level. Re-
lease
[PTT] to receive.
t
After the communication is finished, push
[Moni (Audi)] to
send a ‘Clear down’ signal to terminate the connection.
BIIS
CALL TXCE MON
1234
Appears