Icom IC-F3262DS Operating Manual - page 12
9
2
BIIS 1200 OPERATION
■
Transmitting a call (continued)
D Transmitting an SDM
You can send a preprogrammed SDM to an individual station
or to group stations.
The transceiver has eight memories to store messages.
Push
q
[BIIS Button] to enter the call code memory mode.
• “
” appears.
• The preprogrammed ID is displayed.
Push
w
[CH Up] or [CH Down] to select a desired Individual
ID or Group ID.
e
Push
[BIIS Button] again to enter the message selection
mode, then push
[CH Up] or [CH Down] to select a de-
sired SDM.
r
Push
[Call] to transmit the SDM to the selected station or
group.
• “
WAIT” is displayed while transmitting.
• “
OK” is displayed when an acknowledgement is received.
• “
FAILED” is displayed when no acknowledgment is received.
After a specified time period, the transceiver will return to
t
the stand-by mode.
D Direct message input
(Only 10-key version)
While displaying an SDM, you can edit or change the mes-
sage.
Push
q
[BIIS Button] twice to enter the message selection
mode, then push
[CH Up] or [CH Down] to select a de-
sired SDM.
Push
w
[M] or [#] to enter the message editing mode.
• The first character blinks when
[#] is pushed, the last character
blinks when
[M] is pushed.
e
Push the appropriate digit key,
[0] to [9], to enter a desired
character.
• See the table on the next page for the usable characters.
• Push
[CH Up] to enter a space, and push [CH Down] to delete
the selected character.
r
Push
[#] or wait for the timeout period to move the cursor
to the right, push
[M] to move the cursor to the left.
• After the preprogrammed period has past, the cursor automati-
cally moves to the right.
t
Repeat steps e and r to enter a message of up to 12
characters.
y
Hold down
[BIIS Button] for 1 second to write the new
programmed message into the SDM memory.
• Push
[BIIS Button] momentarily to cancel editing and return to
the original message display.
BIIS
CALL TXCE MON
SDM 1
MESSAGE 1
An SDM is displayed.