Icom IC-M700PRO Instruction Manual - Set Mode
11
5
SET MODE
■
Set mode operation
Set mode operation is used for programming infre-
quently changed values or functions.
☞
NOTE: Some of the set mode items described in
this section are not available on some transceiver
versions.
q
If necessary, push [POWER] to turn power OFF.
w
While pushing [ENT] and [1], push [POWER] to turn
power ON and enter the set mode.
e
Rotate the [GROUP] selector to select the desired
item.
r
Rotate the [CHANNEL] selector to set the values or
options for the selected item.
t
Turn power OFF and then ON again to exit the set
mode.
[POWER]
Status
Item
[ENT]
[1]
(1) Antenna tuner
The transceiver has several tuner control systems for
use with an optional Icom antenna tuner. Select the
condition, depending on the antenna tuner you are
using.
☞
NOTE: An internal switch selection may be re-
quired when using a non-Icom tuner (p. 19).
AT-130
(default)
AT-120
AH-3
(2) Automatic tuning operation
When the optional AT-130 automatic antenna tuner is
connected, tuning can be started automatically with-
out the [TUNE] switch, for instant operation.
If manual tuning is required, this automatic operation
can be deactivated.
Tuning starts when pushing
[PTT] on a new frequency.
Tuning starts only when
[TUNE] is pushed.
(default)
(3) Scan type selection
This item sets scan to function as “channel scan” or
“channel resume scan.”
Both channel scan and channel resume scan search
around a user selected channel or search in the band
when a channel is selected.
Channel scan
Scan is canceled when
transmitting.
Channel resume scan
Scan pauses when squelch
opens, then resumes after
10 seconds.
(default)
■