Icom IC-M700PRO Instruction Manual - Display
4
2
PANEL DESCRIPTION
■
Display
q
RECEIVE INDICATOR
Appears while receiving and when the squelch is
open.
w
TUNE INDICATOR (p. 8)
Flashes while the connected antenna tuner, such
as Icom’s AT-130, is being tuned.
• Tuning starts when transmitting on a new frequency or
pushing the [TUNE] switch.
e
TRANSMIT INDICATOR
Appears when transmitting.
r
S/RF METER
➥
Shows the relative received signal strength while
receiving.
➥
Shows output power while transmitting.
t
CHANNEL/VFO INDICATOR (p. 5)
➥
Shows the selected group and channel in the
memory mode.
➥
“FREQ” appears in the VFO mode.
y
SQUELCH INDICATOR (p. 9)
Appears when the squelch is ON.
TUNE
DUP
SIMP
TX
RX
SCAN
SQL NB
AGC
AGC
ALM
q
w
e
r
t
y
u
i
o
!0
!1
!2
!3
u
SCAN INDICATOR (p. 6)
Appears when the scan function is in use.
• The scan function is not available on some versions.
• Pushing [SCAN] starts and stops the scan.
i
NOISE BLANKER INDICATOR (p. 9)
Appears when the [NB] switch is turned ON.
o
AGC OFF INDICATOR (p. 9)
Appears when the [AGC] switch is pushed to indi-
cate the AGC function is deactivated.
!0
MODE READOUT
Shows the selected operating mode (type of emis-
sion).
!1
SPEAKER OFF INDICATOR
Appears when the [SPEAKER] switch is pushed to
indicate the front panel speaker is deactivated.
!2
FREQUENCY READOUT
➥
Shows the selected frequency whether in the
memory mode or the VFO mode. (p. 5)
➥
Shows the transmit frequency (for duplex
channels) when transmitting or when pushing
[TX FREQ]. (p. 8)
!3
SIMPLEX/DUPLEX INDICATORS
These appear to show whether the selected chan-
nel is simplex or duplex.
• In the VFO mode, only simplex channels are available.
• No indicator means that there is no transmit frequency
programmed.