Intermec CV60 Quick Start Manual - Power Supply Connector
CV60 Vehicle Mount Computer Quick Start Guide
3
Power Supply Connector
This connector provides power to the CV60 Computer to one of
the DC power supply kits (6-96 VDC) or to connect the AC
power supply when operating the CV60 Computer from the
desktop mounting stand. You must have a power supply con-
nected to operate the CV60 Computer.
Keyboard Connector
Use this connector to connect the CV60 keyboard or a PC-PS/2
keyboard to the CV60 Computer using the CV60 keyboard
adapter cable. The keyboard and keyboard adapter cable are
accessories, which are sold and ordered separately.
USB Connectors
Use these connectors to attach USB serial peripheral devices such
as keyboards, mice, hubs to the CV60 Computer. The CV60
Computer supports USB version 1.1.
Ethernet Connector
Use this connector for connection to a 10baseT/100baseT Ether-
net LAN.
Attaching an External Antenna
You can use an Intermec-approved accessory antenna to improve
RF communications.
Attaching a Cordless Bluetooth Scanner
You can attach a scanner, such as the SF51 or SX51 Scanner, to
scan and input bar code data. Use the accessory scanner cables to
connect a scanning device.
1
Insert the scanner cable connector straight into the COM1
port on the CV60 Computer.
2
Use a small straight-slot screwdriver to tighten the two screws
in the scanner cable connector and secure the cable to the
CV60 Computer.
3
Attach the other end of the scanner cable to your scanner.
Note: See your Intermec representative for information
about the CV60 Computer and a list of Intermec-
approved accessory antennas for the CV60 Computer.