Intermec CV60 Quick Start Manual - Windows Ce .Net
4
CV60 Vehicle Mount Computer Quick Start Guide
4
Make sure the cable is not pinched or rubbed by any moving
parts on the vehicle.
Windows CE .NET
1
Enable Bluetooth™ settings by selecting Start > Settings >
Control Panel > Local Bluetooth. Tap Turn On if you see the
“Bluetooth is off ” message, check Connectable, then tap OK.
2
Select Start > Run, then browse to Program Files > Intermec
> Network >BluetoothScannerWizard.exe to associate your
scanner with the CV60 Computer.
3
Tap Add Device, then tap Quick Connect (Incoming) to have
the Connection Wizard find your scanner.
4
Scan the bar code, then tap Finish to exit. After association,
enter PIN “0000” in the Authentication dialog box.
Note: If you have any problems scanning the bar code
shown on the display, you can also scan the Bluetooth
association bar code label on the side of the CV60
Computer.