Easycoder 301 paper cutter kit p/n 1-960457-00 edition 1 april 1999 installation instructions.
Intermec easycoder 301 paper cutter– installation instructions ed. 1 1 paper cutter description the easycoder 301 can easily be fitted with an optional paper cutter. The cutter unit is fitted on the same hinges as the front door, which it replaces, and is connected by a single cable to the upper-mos...
Intermec easycoder 301 paper cutter– installation instructions ed. 1 2 paper cutter the cutter is activated by cut or cut on instructions in the easycoder 301 direct protocol. The following values are recommended for cutting between labels and for variable length strip. In both cases, the start adju...
Intermec easycoder 301 paper cutter– installation instructions ed. 1 3 paper cutter installation, cont'd. • fit the two hooks at the rear of the cutter unit on either side of the tear off edge and press down firmly. • the holes in the tabs at the bottom of the cutter unit should be aligned with the ...
Intermec easycoder 301 paper cutter– installation instructions ed. 1 4 paper cutter information in this manual is subject to change without prior notice and does not represent a commitment on the part of intermec printer ab. © copyright intermec printer ab 1999. All rights reserved. Published in swe...
