Intermec Janus 2020 Quick Reference Manual - page 7
JANUS 2.4 GHz Radio Frequency Quick Reference Guide
7
Attaching the JR2020G or JG2020 Antenna
20X0Q.003
Using the JANUS 2.4 GHz Installation Utility
Before you can use your JANUS RF devices in a 2.4 GHz network, you must
configure the radio parameters and load the network software on them. There
are two different installation utility kits:
• The JANUS 2.4 GHz Installation Utility Kit for 1MB devices
(Intermec P/N 064792)
• The JANUS 2.4 GHz Installation Utility Kit for 4MB devices
(Intermec P/N 064672
You need to provide the network software (LAN WorkPlace for DOS or
NetWare Client for DOS) that you install on your devices. The kit provides the
installation utility that merges your network software with the JANUS
software, software for setting a security ID for your network, Intermec and
Novell terminal emulation software that allow you to install terminal
emulation, and boot utilities companion disks that ensure that you will be
running the latest JANUS firmware.
The installation utility creates new drive images for your devices that allows
them to connect with a Novell network or a TCP/IP-based UNIX network
using RF communications. The installation utility runs on a host PC in the DOS
environment and uses a DOS text-based interface to prompt you for
information about your network.