Intermec Janus 2020 Quick Reference Manual - Using The Janus Rf Devices
JANUS 2.4 GHz Radio Frequency Quick Reference Guide
8
Using the JANUS RF Devices
This section contains information on the JANUS RF devices for the 2.4 GHz
network.
Note
: If your device has sent or received TCP/IP packets when it was out of range of an
access point, or if your device was placed in a suspend state, you may notice a delay in
reconnecting to the network. The TCP/IP protocol determines the retransmission
timeout based on the length of time the device is suspended or disconnected from the
network. For example, this delay can be 30 seconds if the device roams out of range for
3 minutes. The maximum timeout can be from 30 seconds to 1 minute.
Using the J2020 User’s Manual With Your JR2020G or
JG2020
Most of the information in the J2020 user’s manual also applies to your
JR2020G and JG2020. However, both of these readers do not have IRL loaded
on them. Ignore the sections in your user’s manual that discuss IRL.
Also, the JR2020G does not have a PC card slot. Ignore sections in your user’s
manual that talk about using PC cards with your reader.
Using the J2050 User’s Manual With Your J2050A or
JG2050
Most of the information in the J2050 user’s manual also applies to your J2050A
and JG2050. However, both of these devices do not have IRL loaded on them.
Ignore the sections in your user’s manual that discuss IRL.
Also, the J2050A for the 2.4 GHz RF network does not have a PC card slot.
Ignore sections in your user’s manual that talk about using PC cards with your
device.
Logging Into or Out Of Novell Software
If you are a NetWare Client user or, if you are a LAN WorkPlace user using
SPX/IPX support, you must use special instructions when logging into a
NetWare server from your JANUS device.
To log into your network
• Type IMLOGIN on your JANUS RF device.
Note
: Do not type LOGIN to log into your network.