Intermec Janus 2020 Reference Manual - Im_Get_Warm_Boot
im_get_warm_boot
3-42
im_get_warm_boot
Purpose:
This function retrieves the current setting of the warm boot status. You can
enable or disable the Ctrl-Alt-Del warm boot key sequence. When disabled,
pressing the Ctrl-Alt-Del sequence does not reboot the reader.
Syntax:
With Intrmecd_IO, Intrmecp_IO;
Use Intrmecd_IO, Intrmecp_IO;
procedure im_get_warm_boot (
warmboot_status : OUT IM_CONTROL;
status_code : OUT System.Word);
IN Parameter:
None.
OUT Parameter:
The warmboot_status parameter is one of the following constants:
IM_ENABLE
The warm boot is enabled
IM_DISABLE
The warm boot is disabled
The status_code is one of the standard status codes defined in Appendix A,
“Status Codes.”
Return Value:
None.
See Also:
im_set_warm_boot
Example
With System, Text_IO, Intrmecd_IO, Intrmecp_IO;
Use System, Text_IO, Intrmecd_IO, Intrmecp_IO;
procedure get_warm Is
warmboot_status : IM_CONTROL;
status_code : System.Word;
begin
im_get_warm_boot (warmboot_status, status_code);
if warmboot_status = IM_ENABLE then
Put_Line ("Warmboot ENABLED");
else
Put_Line ("Warmboot DISABLED");
end if;
end get_warm;