? 20 17 j&m cor poration. All rights reser ved. 9/1 7 warning: the speakers provided in this kit have an impedance of 2-ohms. They are designed for use with the 2006-2010 harley harmon kardon audio system only. Use of these 2-ohm speakers on the 1998-2005 harley audio system can and will cause perma...
Product overview this is the new j&m stage-4 rokker® xxr custom 630w 4-speak- er/amplifier installation kit for your 2014-2018 harley streetglide with the harley boombox 6.5gt premium or 4.3 standard radio. At the very heart of this system is our in-fairing mounted 4 channel rokker xxrp amplifier ra...
8. Unplug the speaker wires from the speaker and set aside. 9. Remove the stock grill from the inner fairing by removing the 3 attachment screws. Very important: discard these screws as they will not be used again. (figure d) 10. Install the new ‘j&m grills using the (3) #12 x ½” countersunk self-ta...
Saddlebag-lid speaker installation 1. Remove the windshield, outer fairing shell, vent below windshield, fuel tank and seat. 2. From the top of the saddlebag lid, remove the 4 screws securing the speaker and as you remove the stock harley speaker from the lid, unplug the wire connection at the botto...
4. Position the speaker down into the lid to determine if the 3” hole needs to be enlarged slightly in any direc- tion, to completely clear the rokker xx speaker magnet. A dremel tool with rotating bit can be used to enlarge this opening. 5. Place the included plastic protective magnet cup down into...
7. Mark the second of three 9/64th” holes to be drilled, drill the hole and then insert the 6-32 x ½” allen head screw, with washer, up thru the bottom of the basket, thru the cup and secure using the supplied nut plate. 8. Mark the third 9/64th” hole to be drilled, drill the hole and then insert th...
Amplifier installation 1. Remove the windshield, outer fairing shell, vent below windshield, fuel tank and seat. 2. Remove and replace the stock metal tray above the radio with the j&m amplifier mounting tray by removing the 4 screws holding the tray to the radio, 4 screws holding the tray to the sp...
Rokker® xxrp 630 full range class d amplifier output power (rms) @ 1% thd 1000hz 14.4v cea 2006 stereo @ 4ohms 4 x 157.5 watts – 630w rms total stereo @ 2ohms 4 x 157.5 watts – 630w rms total frequency response -3db 1hz - 69khz capable s/nratio separation >90db >74db input sensitivity .35v - 3.9v in...
Warranty registration form please fill out this card completely and mail it immediately after purchase. Please be sure that your zip code and serial number (if applicable) are legible. This will help us to serve you better. (please print) name ________________________________________________________...
