J&M Corporation XXRK-630SP4-14SG-ST4 Installation instructions manual - page 2
Product Overview
This is the new J&M STAGE-4 ROKKER® XXR Custom 630w 4-speak-
er/amplifier installation kit for your 2014-2018 Harley StreetGlide
with the Harley BoomBox 6.5GT Premium or 4.3 standard radio.
At the very heart of this system is our in-fairing mounted 4 channel
ROKKER XXRP amplifier rated @ 157.5w RMS per channel X 4 to
provide up to 630w total RMS power!
The amplifier will be custom tuned for use in conjunction with your
specially FLASHED Harley Infotainment radio (Diag4bike digital
technician “J&M Audio Custom” menu option), to provide THE BEST
on-highway volume, clarity and overall performance available, from
your music source selections of FM stereo, XM sat radio, Smartphone
or USB thumb drive.
Included are J&Ms fully weatherproof 6.71” ROKKER XXR fairing
speakers featuring a high-tech woven-fiber woofer cone & a mas-
sive high-density high-flux strength Neodymium magnet structure
with large center & perimeter positioned voice coil cooling vents, to
provide for maximum heat dissipation when operating at high volume
levels for extended periods.
The custom designed speaker grills with mounted high-output dome
tweeters are also weather-proof and shock-proof for maximum long-
term durability.
Also included are 2 of J&Ms 5X7” ROKKER XX speakers for the rear
saddlebag-lid position, 2 of J&Ms saddlebag lid speaker grills, along
with the custom complete saddlebag speaker wiring harness. (The
Harley saddlebag lids themselves designed for 5X7” speakers are
NOT included with this kit & are an extra cost item).
This STAGE-4 ROKKER XXR custom installation KIT has been engi-
neered to be 100% plug-and-play for your convenience during the
installation and to maintain the complete integrity of your Harley’s
internal wiring harness.
The new J&M music-source test USB thumb-drive is also included for
your performance comparison testing.
Fairing Speaker Installation
1. Remove the windshield and outer fairing clamshell completely.
Important Note: If the bike is equipped with the Harley CB radio
module, ensure that the CB module is removed before removing
the applicable speaker pod assembly.
RIGHT SPEAKER
2. Remove the three 7/16 attachment screws from the inner bottom
edge of the speaker pod. (Figure A)
3. Remove three 3/16 Allen head screws on the outside edges of
the speaker pod. (Figure B)
4. Remove the two 5/32 Allen head screws from top edge of metal
mounting tray. (Figure C)
5. Unplug the wire connection for the cigarette lighter socket from
the speaker pod.
6. Remove the pod from the fairing.
7. Remove the speaker from the pod by removing the 4 retaining
screws.
Fig. B
Remove screws
Remove screw
Fig. A
Remove screws