J&M Corporation XXRK-630SP4-14SG-ST4 Installation instructions manual - page 6
7. Mark the second of three 9/64th” holes to be drilled,
drill the hole and then insert the 6-32 X ½” Allen
head screw, with washer, up thru the bottom of the
basket, thru the cup and secure using the supplied
nut plate.
8. Mark the third 9/64th” hole to be drilled, drill the
hole and then insert the 6-32 X ½” Allen head screw,
with washer, up thru the bottom of the basket, thru
the cup and secure using the supplied nut plate.
9. Completed protective cup installation and attach-
ment as shown below.
10. Plug the wire to the back of the 5X7” ROKKER XX
speaker and secure in place using the two rear
mounting screws ONLY and tighten.
11. Using a 7/64” drill bit, drill new mounting holes for
the front 2 mounting screws, then install and tighten.
9. Reinstall the speaker grill using the same 4 mounting
screws that you removed previously.
10. Repeat the entire process with the opposite saddle-
bag lid.