J&M Corporation XXRK-630SP4-14SG-ST4 Installation instructions manual - page 4
Manual is about: STAGE-4 ROKKER XXR
Custom 630w 4-Speaker/
Amplifier Install Kit for
2014-2018 Harley
StreetGlide/Ultra
of
9
Saddlebag-Lid Speaker Installation
1. Remove the windshield, outer fairing shell, vent
below windshield, fuel tank and seat.
2. From the top of the saddlebag lid, remove the 4
screws securing the speaker and as you remove the
stock Harley speaker from the lid, unplug the wire
connection at the bottom of the speaker.
3. Set the ‘J&M ROKKER XX speaker down into the bas-
ket and mark the position over the very center of the
magnet. Using a 3” hole saw, drill a 3” hole into the
bottom of the speaker shield basket using this mag-
net center location for the hole-saw pilot bit. (This
3” hole is to allow the 5X7” ROKKER XX speaker
magnet to breathe and cool the voice coil under high
load or volume levels)