JabloCom EYE-02 User Manual - 3.3 Working Modes
EYE-02.ENG.MAN.User_Manual.21
- 6 -
EN
EN
U
se
r G
ui
de
Remote control navigation
WATCH
ENROLL
TEST
REPORT
SLEEP
CONFIG
3.3 Working Modes
The EYE-02
camera
has three main working modes:
SLEEP
,
WATCH
and
CONFIG
.
Mode
Description
Button on
the Remote Control
SLEEP
SLEEP
mode is the camera's stand-by mode. The camera doesn’t detect any
movement in the targeted area and the major detectors are disabled. The only
active detectors are those that protect the camera itself against an unwanted
manipulation by an intruder.
WATCH
In
WATCH
mode, the camera guards fully the targeted area and all detectors are
active.
CONFIG
CONFIG
mode allows the user to change the camera settings and switch the
camera to other special modes (
ENROLL
,
TEST
,
USB
).
and
together
The chosen camera mode is terminated by switching to a different camera mode. Camera signalizes its current mode
to the user by LED lights and acoustic signals.
Camera Mode
LED lights signaling
Acoustic signal
WATCH
Lights are off.
One long beep
SLEEP
Green light is permanently on.
Two long beeps
CONFIG
Red and Green lights blink slowly
together.
Three long beeps
ENROLL
Red and Green lights slowly blink
alternately.
One short beep
ERROR
Red light is permanently on
1
.
Incorrect operation
with remote control
Four short beeps
Camera is starting up or
shutting down or USB
mode is in progress
Green light flashes rapidly
1
3.4 Config Mode
CONFIG
mode allows the user to change the camera’s settings.
To enter
CONFIG
mode using the remote control, press the
and
buttons simultaneously – the red and green
LED lights on the front panel will start to blink slowly together.
From
CONFIG
mode is possible to switch to other special modes (
ENROLL
,
TEST
,
REPORT
,
USB
).
1
The Red light goes out when the fault has been resolved or the user has switched mode.