JabloCom EYE-02 User Manual - Gsm
EYE-02 User Guide
- 14 -
S
WITCH THE CAMERA
O
N AND
O
FF
To switch the camera ON, press and hold the power button on the back panel of the camera. Keep
holding button until the green light on the front panel switches on. The start-up process has started
and you can release the button. The camera also starts up automatically after connected to an AC
adaptor.
To switch the camera OFF, make sure that it is in
S
S
L
L
E
E
E
E
P
P
or
C
C
O
O
N
N
F
F
I
I
G
G
mode. Disconnect the power
cable from camera and press and hold the power button on the back panel for 3 seconds. When the
green light on the front panel switches off, the camera shuts down and you can release the button.
Note: Whenever the camera is expected to be switched off for a longer time or for transportation it is
strictly recommended removing the backup battery from camera.
M
ICRO
SD
CARD
Your camera is equipped by SDmicro memory card slot providing the possibility of further extension
of internal storage capacity of camera. Camera comes from production with inserted 1(2)GB memory
card.
JABLOTOOL software allows you to access the SD card as a standard flash disk (EYE-02/Advance
user/Mass storage device). Other camera functions are blocked during PC direct access to SD card.
Exploring SD card you may find folder structure like this:
HISTORY
This folder consists the files with complete (all details) log of
event history. Files are stored sequentially in format
“ev00001.txt”.
PICTURE
Archive of static JPEG files recorded at ALARMs
(“p0065401.jpg”)
VIDEO
Archive of video files recorded at ALARMs (“vid01021.avi”)
VOICE
This folder consist the language dependent voice records for call
control assistance
config.ini
this file consists the current configuration of EYE-02 – can be
used for backup or restore of configuration.
Note: More than 1000 event records can be stored on the 1GB card. If the memory card is full, the
oldest record of the same type is automatically erased.
R
ESET TO FACTORY DEFAULTS
If you need to reset the whole camera setting to factory default values follow this guide:
WARNING: ALL USER SETTINGS AND CONTACTS WILL BE DELETED!
•
Switch the camera off
•
Press and hold the POWER button on the back panel of the camera,
•
Connect the AC adaptor while
holding
the POWER button for another 6 seconds
•
Wait until green and red lights blink together
•
Release the POWER button
•
All settings and external devices have been deleted – the camera is in
C
C
O
O
N
N
F
F
I
I
G
G
mode and
waits for enrolling the remote control and basic contact setting
GSM
NETWORK SETTING
Camera needs the correct setting of GSM network parameters. These parameters depend on the
country where you live and the GSM network you use.
Camera can automatically adjust to correct setting for most of GSM networks. In case there are some
specific settings of your GSM network which you got from you GSM network operator, you may
configure it manually in JabloTool, Device configuration, tab GSM network.
Note: Please contact your GSM network operator for detail parameter setting.