Jablotron JA-63 „PROFI“ User Manual - page 14
• switch the control panel to the user mode (entering F0 master code)
• open the cover of the detector (keypad)
• replace its batteries with new ones (use only corresponding size and good
quality alkaline batteries). Wait for approximately 20 seconds before
inserting batteries
• close the device’s cover and test its function.
• to exit User mode, press the N key on the keypad
Note: normal battery life in wireless items is about 1 year. Exposure to a very cold
temperature, frequent triggering or low initial battery capacity can shorten the
battery life.
Recommendations: the system should be annually inspected by a professional
installer. The control panel and the outdoor siren back up batteries should be
replaced with new ones after 5 years.
7 Enrollment of the control panel to UC-2xx modules
The wireless control panel can send data to UC–216, UC–222 and UC-260 output
modules. To enroll the JA-63 control panel to the UC-2xx:
• switch the control panel to the user mode (entering F0 master code)
• switch the UC-2xx to learning mode (see its manual)
• enter 299 on the alarm system keypad – the control panel will enroll
• press the N key on the keypad to exit User mode,
Alarm system JA-63 „PROFI“
- 14 -
MGK51501