Jabra BT5010 Multiuse User Manual - page 7
RELEASE YOUR JABRA
GB
CN
JA
KO
TH
MA
CN
Jabra BT5010 Bluetooth headset
GB
CN
JA
KO
TH
MA
CN
4. Wear it how you like it
The Jabra BT5010 is ready to wear on your right ear. If you prefer the left, pull
out the earhook and rotate and insert as shown. (See fig 4).
For optimal performance, wear the Jabra BT5010 and your mobile
phone on the same side of your body or within line of sight. In general,
you will get better performance when there are no obstructions
between your headset and your mobile phone. (See fig 5)
5. The sliding boom arm
The sliding boom arm is used for answering and ending calls, but will also
give an increased audio quality when extended.
To answer an incoming call just extend the boom arm to an open position
and to end the call slide the boom arm back to a closed position.
6. How to…
Answer a call
• Open the sliding boom arm to answer the call
End a call
• Tap the answer/end button to end an active call
or
• Close the sliding boom arm to end an active call
Make a call
• When you make a call from your mobile phone, the call will (subject to
phone settings) automatically transfer to your headset. If your phone
does not allow this feature, tap on the Jabra BT5010’s answer/end
button to transfer the call to the headset.
Reject a call*
• Press the answer/end button when the phone rings to reject an
incoming call. Depending on your phone settings, the person who called
you will either be forwarded to your voice mail or hear a busy signal.
Activate voice dialling*
• Tap the answer/end button. For best results, record the voice-dialling
tag through your headset. Please consult your phone’s user manual for
more information about using this feature.
Redial last number*
• Press the answer/end button.
Adjust sound and volume
•
Press the volume up or down (+ or -) to adjust the volume. (Volume up
button as per default on top of the headset when worn on the right ear).
• To mute,
press both volume up and down at the same time. A low beep
alert plays during a muted call.
• To un-mute,
tap either of the volume buttons.
Call waiting and placing a call on hold*
This lets you put a call on hold during a conversation and answer a waiting call.
• Press the answer/end button once to put the active call on hold and
answer the waiting call.
•
Press the answer/end button to switch between the two calls.
•
Tap the answer/end button to end the active conversation.
* Functions marked with * are dependent on your phone supporting these
features. Check your phone’s user manual for further information.
Enable/disable vibrator
• Press and hold both volume buttons in standby mode.
Volume buttons
To change the orientation of the volume buttons (default setting is for right
ear wearing mode)
• Press and hold the answer/end button in standby mode and tap the
desired up button.
7. Battery Indicator
When the Jabra BT5010 is turned on or a button is pressed more than 1 minute
after last button press, the LED indicates the battery level of the headset.
What you see
Battery level
4 Green flashes
75% - 100% Charged
3 Green flashes
50% - 75% charged
2 Green flashes
25% - 50% charged
1 Red flash
Less than 25% charged
This Manual: http://www.manuallib.com/file/2532845