Jackson Systems Comfort System T-32-P Operation Manual - page 4
Programming 4 daily events
The T-32-P can be programmed to provide 4 individual time-of-day temperature settings for each day
of the week.
Each event is noted on the LCD by numerals
At the start of each event, the programmed heating and cooling temperature will be maintained until
the next event starts.
1
2
3
4
MODE
O/RIDE
PROG
FAN
Cool
Heat
PROG
KEY
Entering the program mode
PROG
MON
PROG
PROG
Hold the
key down for 3 seconds.
The display will show the number
and the day
will flash.
Use the up ( ) or down ( ) key to set the day you
wish to start programming.
Press the
key again and the hour will flash.
Use the up ( ) or down ( ) key to set the time you
wish program
to start. Make sure that the AM / PM
is correct.
Press the
key again and the minutes will flash.
Use the up ( ) or down ( ) key to set the minutes for
program
to start.
1
1
1
UP / DOWN
KEYS
1
1
1
1
1
1
Press the
key again and
or
will be displayed along with the temperature value. Use
the up ( ) or down ( ) key to select the desired heating or cooling temperature to be maintained for
the program
time period.
Press the
key again and the opposite mode and a temperature value will be shown on the
LCD.
PROG
Heat
Cool
PROG
Use the up ( ) or down ( ) key to select the desired temperature to be maintained for the
program
time period.
Note: There must be at least a 2 degree difference between the heating and cooling temperatures.
The heating temperature must always be lower than the cooling temperature. If you set the heating
or cooling temperature closer than the minimum value, the T-32-P will automatically move one of the
temperature settings to maintain the 2 degree difference.
1
1
1
1
3