Jade RJGR Installation Instructions Manual - Oven

13

If the flames are yellow, soft, lazy with indistinct cones,

it signifies insufficient air.  For natural gas it is normal

that the burners have blue flames with little orange

tips.  For propane, it is normal to have blue flames with

yellow tipping.  If the flames are noisy and tend to lift

away from the burner, then it means excessive air.  To

adjust the air, loosen the Phillips screw on top of the air

shutter and turn air shutter to correct setting.  Tighten

the screw after adjustment.  It is normal that the smaller

burner has sharper flames than the large burners.

Turn the burner knob to LOW  (simmer)  setting.  At

this setting, the burner ports must be fully lit with the

smallest possible flames without flickering.  If some

ports do not stay lit or if the flames are high, adjust-

ment is necessary.  To adjust, set knob to low and pull

out the control knob.  With a skinny flat screw driver

(1/8" wide)  locate the adjusting screw at the center of

the valve stem.  Turn the screw clockwise to lower the

flame and counter clockwise to increase.

  OVEN

red color to emit infrared heat. There is no adjustment

to the infrared burner.

NOTE: The noise of gas flowing into the infrared

burner is normal.

The ceramic burner surface will glow into an orange

  INFRARED  BROILER

The oven burner and igniter are accessible by remov-

ing the oven bottom pan.  The oven uses a glowbar

ignition system.  To light oven turn power switch on.

Push and turn oven thermostat to desired setting.  The

orange indicator “BAKE” light will come on.  The glowbar

igniter will glow and after a few seconds the oven burner

will ignite.  The burner flames should  be blue with dis-

tinct cones 1 to 1 1/4 inches high. If the flames are yel-

low, soft, lazy with indistinct cones, it signifies insuffi-

cient air. For natural gas, it is normal that the burners

have blue flames with little orange tips.  For propane, it

is normal to have flames with yellow tipping. If the flames

are noisy and tend to lift away from the burner then it

means excessive air. To adjust burner flames, loosen

the air shutter screw and turn air shutter.  Retighten the

air shutter.

NOTE:  The noise of gas flowing into the burner is nor-

mal.

The infrared broiler uses a glowbar ignition system.  To

light the broiler, turn power switch on, push and turn

oven thermostat to broil.  The red indicator “BROIL”

light will come on.  The glowbar igniter will glow and

after a few seconds the infrared burner will ignite.