Jade RJGR Installation Instructions Manual - Curb Base Installation
5
CURB BASE INSTALLATION
The curb base must be installed after the range has
been leveled and set properly in its final location.
To install the curb base, simply remove the kick plate
(the panel immediately below the oven door) and lo-
cate the mounting holes at the front of the range base.
Secure the curb base to the front of the range base
using the two hexagonal sheet metals screws provided
with the curb base. If the legs are adjusted to the
minimum height of 4 inches, the curb base can have
0 to 1/8 gap between the floor. When the legs are
adjusted higher, the gap can be as high as 2 inches
which may not be visually objectionable and not need
a filler. If a filler is desired, build a filler attached to the
floor or to the adjacent cabinets using screws or other
removable fasteners, so that the range can be readily
removed if necessary.