Kalamazoo K1000HB Use And Care Manual - Leak Testing
1.800.868.1699
13
Leak Testing
Although gas connections on the grill are leak tested at the factory prior to
shipment, a complete test must be performed after installation due to possible
mishandling during shipping or installation.
Periodic checks are also recommended. Immediately check for leaks if you
smell gas.
Never use an open flame to look for leaks.
Before Testing: Extinguish all open flames. Do not smoke.
You will need a spray bottle, a brush or a rag. For LP units using a 30-pound cylinder, a full cylinder should
be used.
IMPORTANT:
Homeowners should only check for leaks on the gas connections that are external to the grill. If
the valves or other internal connections need to be checked, please call a qualified technician or Kalamazoo
Outdoor Gourmet customer service at 1.800.868.1699.
To Conduct the Test:
Make a soap solution of one part liquid dish soap and one part water.
Make sure all grill control valves are in the OFF position. Turn the gas supply ON. Use a spray bottle, brush
or rag to apply the mild soap solution to all connections from the supply line or LP cylinder to the connection
on the grill. Check all connections. Soap bubbles will appear at any connections with a leak. Turn OFF the gas
supply and tighten any leaky connections. Recheck, applying more mild soap solution.
Electrical Connection
The grill requires AC power for the control panel lighting and rotisserie motor
functionality. It must be connected with an outdoor-rated, grounded electric
extension cord.
The grill, when installed, must be electrically grounded in accordance with local codes or, in the absence of
local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.1.
See additional electrical precautions on page 76.
IMPORTANT: Do not use the grill until all connections have been
checked and do not leak.