Kangaroo Hillcrest ABX Manual - page 15

Assembl

y

14

5. Connect the plug from the Upper Caddie Structure to the receptacle in the Chassis. 

(Figure 3) 

Note: Always handle the plug when connecting or disconnecting the control cable. Pulling on the wire  

can cause damage.

6. Connect the Electronic Front Drive by inserting the black plug into the receptacle on the lower left of the 

Remote Receiver. Push inward on the lock ring while twisting it clockwise until it stops. (Figure 4)

7. Set your battery into the battery tray with the terminals to the back of battery tray.

 (Figure 5)

a.  Connect the 

REd

 clip to the (+) positive terminal.

b.  Connect the 

BlACK clip to the (-) negative terminal.

Note: If the cables are accidentally reversed, your X-Series will not run until the polarity is corrected. 

(Your X-Series is equipped with reverse-polarity protection, and connecting the terminals backwards 

will not harm you or the unit.)

Adjustments

Your X-Series comes with an assortment of Allen-type wrenches. They are provided for adjustments, keeping 

screws tight, and for adding optional equipment. 

Draw latch: